PRODUCTS
       
 
  FASALUX
  Impregnation
   FASALUX
 Exterior wall (fasade) paint
 
         



Content: Solution of ploy-acryl resin.

Purpose: Impregnation of mineral surfaces which absorb well (lime cement mortar with sea sand, concrete with crushed stone, gas-concrete, cement-asbestos slabs, old mineral paints, plaster, artificial mineral substance, laminated floor, chipboard, etc.) before application of FASALUX exterior wall paint.

Typical characteristics: Penetrates well into the surface, makes the loose layers of the surface solid again and binds well the new layer of paint.

Technical characteristics: Appearance of the coat: colourless, matte.
Drying time: 8-10 hours before the following coat
Viscosity: 12-16 s by 4 DIN 53211 at 20C.
Flash point: above 28C, Abel-Pensky, closed receptacle.

Usage: 1 kg for 3-6 m2 in one layer, depending on the porosity structure of the surface.

Application: The surface must be dry and clean from any loose layers of dirt and dust. Applied in two layers with 24 hours in between- using the brush, the roller or by sprinkling. Not to be thinned! The tools are washed by oil thinner.

Assortment: white, brown, oxide red, chrome green, black, pastel colours and colours by order.

Packaging: by order

Storage: In sealed original packaging, out of reach of direct sunlight or other heat source, at temperatures up to 30C.

Expiry period: Under the conditions stated above and in original packaging, 36 months.






 

Content: Poly-acryl resins, pigments and dyestuff and additives.

Purpose: Long-term protection and decoration of the surfaces made of mineral and other kinds of substance in external conditions: facades, fences and other surfaces made of mortar, concrete, gas-concrete, asbestos-cement slabs, artificial mineral substance, plaster, chipboard, laminated floor, etc. Not for hard-wearing horizontal surfaces (garage or balcony floors, etc.)

Typical characteristics: Excellent adhesive power, resistant to alkali and atmospheric influence, including sea and industrial atmosphere. Selective permeability, "breathing" of the wall. Can be used on temperatures as low as -10 C.

Technical characteristics: Appearance of the coat: coloured, matte.
Dry substance: 661% of the weight.
Viscosity: weakly tyxotrophic .
Flash point: above 28C, Abel-Pensky, closed receptacle.
Density: 1.420-1.450g/cm3

Usage: 1 kg for 4-6 m2 in one layer, depending on the porosity structure of the surface.

Application: The surface must be clean from loose layers of dirt and dust. Applied in two layers with 24 hours in between - using the brush, the roller or by sprinkling. The first coat is thinned with 10-15% of oil thinner, and the second one is applied un-thinned or slightly thinned (up to 5%).

Assortment:
white
cream
brown
oxide red
chrome green
black
? colours by order


Packaging: 1 kg/ 4 kg/ 25 kg

Storage: In sealed original packaging, out of reach of direct sunlight or other heat source, at temperatures up to 30C.

Expiry period: Under the conditions stated above and in original packaging, 36 months.






 

   
 
     
©2004 Yellow Pages Co.